|
THINGS YOU SHOULD KNOW!
A side our committment of excellent service, we are also committed to our communities we serve. Please join us for a very special session on June 9, 2009 with Motivational speaker Don Spradling, with all proceeds donated to the Boys and Girls Clubs of Concord and Hopkinton. Please visit www.dalynsolutions.com/thepathahead
Before you purchase ANY maintenance-free gutter system, you should educate yourself on the following basic installation information...
Dalyn Solutions Installation Specifications
The design of any gutter system is based on the existing conditions at the site. Roof type and roof condition along with fascia type and fascia condition are the primary factors to be considered. The “levelness” of the existing fascia must also be taken into consideration.
Dalyn pitches the gutter using a level inside the gutter and achieves a pitch that equates to approximately ¼” in 10 feet. If the existing fascia is pitching the opposite direction of the desired drainage location, an alternative design may be needed. Dalyn performs a number of customized installations based on the existing conditions. When designing any system Dalyn considers the function as well as the aesthetics of the finished product. An installed system that looks good but doesn’t perform as needed is of little value; in addition, a system that will function but looks awkward on the building is not a good solution either.
The following is a list of the most common conditions and the applications used under those conditions.
Flat plumb fascias:
Dalyn uses the hangtite hidden hanger, screw attached through the gutter into the fascia at 16 inches on center using Deckmate Evercoat 1-5/8” fasteners. A continuous bead of silicone is applied to the back of the gutter before it is attached to prevent water from getting between the gutter and fascia.
Angled fascias:
Dalyn uses the hangtite hidden hanger, screw attached through the gutter into the fascia at 16 inches on center using Deckmate Evercoat 1-5/8” fasteners. Aluminum wedges matching the color of the gutter are applied every 16 inches on center to keep the back of the gutter plumb.
No fascia or steep angled fascias:
Dalyn uses strap hangers screw attached to roof under shingles at 16 inches on center using Deckmate Evercoat 1-5/8” fasteners. At roofs with metal flashings, strap hangers can be screw attached to roof over the flashing and sealant applied over screws, or the fascia can be built-out to allow the hidden hanger application.
Fascia Build-outs:
Dalyn performs a variety of fascia alterations in order to accommodate the gutter installation best suited for your particular project. The fascia work can range from adding a single board to complete removal and rebuilding of the fascia. If fascia work is required as part of your project, your Dalyn representative will discuss these options during the onsite review.
Downspouts:
The number and placement of the downspouts can be a major contributor to the aesthetic appeal of the completed project. On most residential projects, Dalyn uses 2-1/2” x 3” fluted downspouts with a 2-3/4” outlet at the gutter. The larger 2-3/4” outlet allows the downspout to handle the runoff for up to 800 square feet of roof surface. Larger 3”x4” downspouts are also available for conditions where the distance or the roof surface requires a larger capacity. Downspouts are attached using pipe bands which are screwed to the building and wrapped around the downspout providing a secure “vibration free” installation. ½” stainless steel zip screws in a painted finish to match are used to secure the pipe bands to the downspout. This allows the downspout to be easily removed by the homeowner for painting or cleaning of siding.
Dalyn Solutions
Worth's Rain Gutters
14 Chenell Dr
Concord, NH 03301
603-223-9985
Copyright 2006 Dalyn Solutions All rights reserved.
|